Author: MlePh, published on 2015-12-05
Hello to all! To be honest – i was really suprised to see my design on the featured page! I think i can improve the design a bit by adding some bearings. Hold for one or two weeks to make an update. I’m quiet busy at my work right now but will try to change what i think has to be changed..
That been said, thats the old text:
Changed the design of my previous air raid siren. Added a gear box, a hand crank, a turbine and a lot of screws – everything 3D printed…
Be careful when using it! Dont touch the moving parts while they are rotating!
10.02.2016 – update:
- made a smaller version of part “Gehause1” so it also fits on a smaller build plate
- made an assembled all-in-one-version
Printer Brand: MakerBot
Printer: MakerBot Replicator 2
Infill: 10 %
The rotor-parts should be glued together.
Use some oil for the moving parts!
License: Creative Commons – Attribution