Micrometer Set Inch/Metric

2017-02-10 admin 0

Author: LtDan – Inch and metric versions of a two piece printable micrometer. The Inch micrometer has a travel length of 2.5 inches and the metric has a travel length of 30 mm. I have included an addi…

Corner Clamp (One Inch)

2017-02-10 admin 0

Author: flemish4 – 1″ corner clamp for holding two 1×2 pieces of wood together for drilling and screwing when making frames.
Uses 8mm hex bolt with a captive nut glued in the middle.
Print with a high…

Lock Pick Set Card

2017-02-09 admin 0

Author: Lockheart – The idea for a lock-pick set that you could carry around in your wallet came to me when I began to learn how to pick locks this summer for fun. It was partly inspired by the veloci…

Miter Razor

2017-02-09 admin 0

Author: Simonarri – Here’s a hand tool for making miters and chops in small materials. Good for model building, doll house trim, etc. It uses a common utility knife blades and 4-40 screws. The model i…

Pump Hand Drill

2017-02-09 admin 0

Author: speedy777 – Just for the record, I have always credited Performance 3D for the original concept and said this was my rendition of their drill as it was not available for download at that time….

Center Finder

2017-02-09 admin 0

Author: Mobilow – A clever to tool to mark the center of a wooden sheet or beam. Just place the two legs around your piece you like too have marked in the center and mark a point or draw a line with a…

Nasa Space Wrench (actual file from Nasa)

2017-02-09 admin 0

Author: nibblernibbles – Hot off the press …. 23rd December…just in time for Christmas. This is the first ever tool emailed to space and printed in orbit! I haven’t even had time to print it yet, …

Razor Guillotine

2017-02-09 admin 0

Author: Botmaster – I needed a way of cutting heat shrink tube into repeatable short lengths. It also needed to be safe and not have any exposed blades. the hole is 6mm sq, the largest I could make it…

1 2 3