Cooling Fan Duct for E3D All Metal Hot End V6

Author: Zeppelinum, published on 2014-08-07

Click this button to get the 3D model

Summary

This is a remake of the fan duct for cooling the E3D Hot End designed by euphy and available at http://www.thingiverse.com/thing:120249
I tried the original one with my v6 hotend but one side of it was too close to the source of heat and melt at some point, this is why I change its geometry a bit to make sure it far enough to prevent any damage.
I use this with Greg’s Wade extruder on my Prusa i3.
Enjoy )

Instructions

you’ll need to use screws to connect your 30mm and 40mm fans or you may use M3 bolts like I did, no nuts needed with this design.

License: Creative Commons – Attribution – Share Alike

Tags: cooling, duct, e3d, fan, v6