Horizontal Spool Roller w/ Adapter for Saintsmart Spools

Author: ichdruck3d, published on 2013-07-13

Click this button to get the 3D model


This is a horizontal filament spool roller derived from http://www.thingiverse.com/thing:31678. I added a adapter for filament-spools coming from Sainsmart with a spool-hole-diameter of 48mm.

I prefer this horizontal position because the ABS from Sainsmart has a bad winding and the boundary is too short which is leading to cable spaghetti in vertical position.

I like this roller very much because it is working very good and I can use the very cheap ABS filament without spaghetti 🙂

Thank you Jack_N!!!

You need the following:

3x Screws M5 X 20

3x Nuts M5

3x Bearings 625 (5 X 16 X 5)

1x Bearing 608

Assemble the 625 bearings to the bearing plate with the screws and nuts. Place the 608 bearing in the middle of the bearing plate.

Here is a video of the roller in action: http://www.youtube.com/watch?v=kQ3xlQT2xA0

You can find the filament here:
or at German Amazon:

License: Creative Commons – Attribution – Share Alike