IKEA Antonius Wall Mount

Author: aubenc, published on 2013-11-12

Click this button to get the 3D model

Summary

A quick’n’dirty OpenSCAD (sorry, there’s nothing parametric in it) to allow us to mount those IKEA clothes dryer in a wall.

We have been using it for a couple of months with all kinds of loads and it’s still holding in place… use at your own risk.

Check the intructions for more details.

Instructions

You’ll need two of them and two screws (and plugs) for each one.

The screws should have a diameter of 4mm (or less, better no…) and at least 45mm length.

I printed them is ABS, don’t remember the layer height but quite coarse (0.20 or 0.25mm), one extra shell (2 in total), 35% infill and finished them with an acetone bath.

License: Creative Commons – Public Domain Dedication