Iron Man Mask at 80%, 90%, and 100% (scaled)

Author: Lgchinadragon, published on 2013-10-25

Click this button to get the 3D model

Summary

This is the helmet made by MaximFilms, but I just cut it up so it can fit on the Replicator 2. The files contain 80% and 90% scales, and if you want, I will do 85% if enough users request it. Enjoy! Also, currently I only uploaded the full set of pieces for 100% and 80% because that was the most I could do during my free time.
UPDATE: I just put in the 90% scaled helmet. I’m sorry that there’s a lot of pieces, and I’ll post pictures of the model as soon as I build it.

Instructions

I’m going to try superglue, but if that doesn’t work, I might scotch tape it and then spray paint over it to cover. Be sure to put on the rafts and supports too! I found that if you didn’t, the model gets knocked over and everything gets messy after that.
Infill: 10%
Layer height: .2 mm
Shells: 2
Resolution: standard

License: Creative Commons – Attribution – Share Alike