Onix

Author: ClassyGoat, published on 2013-12-20

Click this button to get the 3D model

Summary

Wild ONIX appeared!

The 3D model for this originated from this wonderful site that rips Pokemon models from the various games: http://roestudios.co.uk/project/3d-pokemon-models
But then I made it 3D printer friendly!

I welcome anyone to make improvements / remixes of this.

Pokemon Copyright Gamefreak/Nintendo

Instructions

This print was a bit tricky and required a whole lot of supports that were a pain in the Ash to remove. If you can figure out a way to do it with far less supports, I would be delighted to see.

I printed this on a FlashForge Creator 1 (based off of the Replicator 1)
I used grey ABS and sliced with these settings:

3 layer thick raft.
Full Support (YOU MUST USE SUPPORTS WITH THIS MODEL!)
10% Infill
0.2 mm Layer height
3 Shells
40 mm/s feedrate
75 Travel feedrate
230 degree temperature.

It took roughly 4 and a half hours to print.

License: Creative Commons – Attribution – Share Alike

Tags: Onix, Pokemon