Optimized Nonlethal Door Stop Multitool

Author: ChrisMUC, published on 2013-12-11

Click this button to get the 3D model

Summary

Instructions

I printed the door stop with these settings:

  • 0,1mm layer (to produce a nice surface and to make it more stable.)
  • 1mm walls (to make it strong enough to really stop a door.)
  • 20% infill (If you don’t use any infill the part will probably work afterwards, but the top surface could have problems because of the bridging needed. There is no extreme bridging, so it could work. I printed it with infill to make it stronger,too.)
    With these settings and a speed of 50mm/s it consumed 4h 15m of printing time.

License: Attribution – Non-Commercial – Share Alike

Tags: Door, Doorstop, Door_stop, Stop, Stopper