Periodic Table Cribbage Board

Author: ekehoe, published on 2013-10-16

Click this button to get the 3D model

Summary

Probably bigger than it needs to be. A lot of detail so it takes quite awhile to slice up. I rolled ink over the top to make the boxes and letter stand out. The pegs and the lid are a little tight. But I scaled them down a bit smaller than the one I printed for the .thing file that I uploaded, so shouldn’t be an issue anymore.

Instructions

If you use the .thing file it should already be scaled properly. If you are going to use the .stl files, you will need to scale the peg and the lid down 90% to get them to fit properly. I guess I didn’t leave enough of a gap when drawing it up.

License: Creative Commons – Attribution – Share Alike

Tags: periodic_table_of_elements