Author: Normand, published on 2014-07-28
-Easy access to every connector
-Breakable GPIO opening
-Internal mounting holes (4x M2x10 or M2x14)
-Micro SD card does not protrude but still accessible
-Compatible with Raspberry Pi 2 and B+
Raspberry Pi 2 and B+ version have enough power to run a wifi usb stick, 3d printer and logitech camera without another powered usb hub. Reduce the amount of wires around an OctoPrint or Astroprint setup.
Here is a guide to setup and use Astroprint with a 3D printer.
Printed with a Solid Utopia V2 at 0.150mm layer height, 100/120mm/s
2015-01-21 I uploaded a new version with more gap between the usb port and the pcb and more clearance under pcb. The fasteners pad have more strength too.
Printed with a Solid Utopia V2
-0.150mm layer height
4x M2x10 screw or M2x14
Tags: AstroPrint, B_plus, case, Octoprint, Rasberry_PI, Raspberry_Pi_2